Description
Conductivity Controller Dosing setting; 2 Set Point, Time Delay
Work Instruction Digital Conductivity Controller Dosing setting
1. SETTING RELAY OPERATION
SET High limit and Low limit of EC Value for Buzzer / Relay Operation
a) Press the SET button Upper display shows H-EC the higher limit to set and lower display shows the value of H-EC already set Press UP and DN buttons to set Higher Limit
b) press the SET button once again to set Dosing Quantity in ML-1 if EC Value goes higher from H-EC then the concerned dosing pump will dose ML-1
c) Press the SET button once again Upper display shows L-EC the lower limit to set and the lower display shows the value of L-EC already set
d) press SET button once again to set Dosing Quantity in ML-2 if pH Value goes lower from LPH than concerned dosing pump will dose ML-2 quantity
e) Press the SET button again to Set Delay Time DELY in Minutes. It works if EC Value goes more than H-EC or less Than L-EC value than Dosing will Start after this delay for a set value of Quantity in ML-1 or ML-2, after dosing it will further wait for monitoring EC Value before next dosing.
f) Press SET Button again or ENT button to save the changes else change will remove after power OFF
Technical Specifications : Conductivity Controller Dosing setting
- Range: 0000 to 9999 ucm / mcm
- Conductivity : 20µ/cms, 200µ/cms, 2mili & 200mil
- Resolution: 0.01, 0.1
- Accuracy: ±1% @ 25°c
- In Built Display: 4 Digit, Red Led Display
- Selection Calibration: Single Point
- Power Requirement: 230v A.c ± 10%, 50hz Single Phase
- Environment: 5 to 50°c
- Dimension: 96 x 96 x 80 mm
- Weight: 1 Kgs (approx)
- Supply 220 VAc
TDS / Conductivity Meter distributor and supplier ,
Hence (MCS); It is a TDS meter distributor and supplier in India, TDS Meters are used to measure Total Dissolve Salt measured in particles per Millions ie. PPM. We have different type of TDS Meter and Controller for Industrial and Lab Use. Hence please click the link below; to Reed more about. Or Click on Link; to see more products in this category.
- Digital TDS meter Online Panel Mounted for Industrial use
- Digital TDS Meter Table Top for Laboratory Use
- TDS Controller with 1 Set Point 1 Relay Output
- TDS Controller with 2 Set Point and 2 Relay Output
- Sensor / Probe for TDS Meter
Conductivity Meter, Online pH Meter Manufacturers in India
Hence Conductivity Meters are also known as EC meters; EC or measures in UCM and MCM. While we have different type of Conductivity Meter and Controller. Hence please click the link below; to Reed more about given products. Or Click on Link; to see more products in this category.
- Digital Conductivity meter Online used to measure EC value of any solution.
- Digital Conductivity Meter Table Top for Laboratories
Reviews
There are no reviews yet.